KRYLON PRODUCTS GROUP -- 00551 SAFETY ORANGE (OSHA ORANGE), RUST (SUPDAT) -- 8010-00N081280 
=====================  Product Identification  =====================

Product ID:00551 SAFETY ORANGE (OSHA ORANGE), RUST (SUPDAT)
MSDS Date:02/01/1993
FSC:8010
NIIN:00N081280
=== Responsible Party ===
Company Name:KRYLON PRODUCTS GROUP
Address:31500 SOLON RD
City:SOLON
State:OH
ZIP:44139
Country:US
Info Phone Num:800-832-2541; 800-247-3266
Emergency Phone Num:216-292-7400
CAGE:IO479
=== Contractor Identification ===
Company Name:KRYLON PRODUCTS
Address:180 EAST BROAD ST
Box:City:COLUMBUS
State:OH
ZIP:43215
Country:US
Phone:614-431-6600;800-848-9400
CAGE:IO479
Company Name:SHERWIN-WILLIAMS DIVERSIFIED BRANDS, INC.
Address:26300 FARGO AVENUE
Box:City:BEDFORD HEIGHTS
State:OH
ZIP:44146
Country:US
Phone:216-292-7400 OR 216-595-8634
CAGE:09800

=============  Composition/Information on Ingredients  =============

Ingred Name:KEROSENE (PETROLEUM), HYDROTREATED; (MINERAL SPIRITS). VP:
    2.0
CAS:64742-47-8
RTECS #:OA5504000
Fraction by Wt: 42%
OSHA PEL:100 STEL (MFR)
ACGIH TLV:100 TEL (MFR)

Ingred Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
Fraction by Wt: 1%
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9495

Ingred Name:VOLATILE ORGANIC COMPOUNDS (VOC) - 3.60 LESS WATER
    (LBS/GAL)
RTECS #:9999999VO

Ingred Name:SUPDAT:PRODUCTS IS AN IARC, NTP/OSHA LISTED CARCIN. PRLNGD
    OVEREXPOS TO SOLV INGREDIENTS IN ING SECTION MAY CAUSE(ING 5)
RTECS #:9999999ZZ

Ingred Name:ING 4:ADVERSE EFTS TO THE LIVER & URINARY SYS. RATS EXPOSED
    TO TITANIUM DIOXIDE DUST AT 250 MG/M3 DEVELOPED LUNG (ING 6)
RTECS #:9999999ZZ

Ingred Name:ING 5:CANCER, HOWEVER, SUCH EXPOS LEVELS ARE NOT ATTAINABLE
    IN THE WORKPLACE. RPTS HAVE ASSOC RPTD & PRLNGD (ING 7)
RTECS #:9999999ZZ

Ingred Name:ING 6:OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN AND
    NERVOUS SYSTEM DAMAGE.
RTECS #:9999999ZZ

Ingred Name:WASTE DISP METH:AND LOCAL REGULATIONS REGARDING POLLUTION.
RTECS #:9999999ZZ

Ingred Name:OTHER PREC:THE APPLICABLE LIMITS FOR NUISANCE DUSTS ARE
    ACGIH TLV 10 MG/M) (TOTAL DUST), OSHA PEL 15 MG/M3 (ING 10)
RTECS #:9999999ZZ

Ingred Name:ING 9:(TOTAL DUST), 5 MG/M3 (RESPIRABLE FRACTION).
    INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING AND (ING 11)
RTECS #:9999999ZZ

Ingred Name:ING 10:INHALING THE CONTENTS CAN BE HARMFUL OR FATAL.
RTECS #:9999999ZZ

Ingred Name:RESP PROT:RESPIRATOR APPROVED BY NIOSH FOR PROTECTION
    AGAINST NON-VOLATILE MATERIALS IN SECTION 2.
RTECS #:9999999ZZ

Ingred Name:VENT:BELOW APPLICABLE EXPOSURE LIMITS. REFER TO OSHA
    STANDARDS 1910.94, 1910,107, 1910,108.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: IRRIT OF EYES, SKIN & RESP SYS.
    MAY CAUSE NERVOUS SYS DEPRESS. EXTREME OVEREXP MAY RSLT IN
    UNCONSCIOUSNESS & POSSIBLY DEATH. SIGNS & SYMPS OF OVEREXP: HDCH,
    DIZZ, NAUS, & LOSS OF COORDINATION A RE INDICATIONS OF EXCESSIVE
    EXPOS TO VAPS/SPRAY MISTS. REDNESS & ITCHING/BURNING SENSATION MAY
    (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:INDICATE EYE/EXCESSIVE SKIN EXPOS.
    CHRONIC:CERTAIN PRODS CNTN QUARTZ (SEE INGRED). QUARTZ, ALSO KNOWN
    AS CRYSTALLINE SILICA, IS LISTED BY IARC. LONG TERM EXPOS TO HIGH
    LEVELS OF SILICA DUST,  WHICH CAN OCCUR ONLY WHEN SANDING/ABRADING
    THE DRY FILM, MAY CAUSE LUNG DMG (SILICOSIS) & POSSIBLY CANCER.
    (SUPDAT)
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.

=======================  First Aid Measures  =======================

First Aid:INHAL: IF AFFECTED, REMOVE FROM EXPOSURE. RESTORE BREATHING.
    KEEP WARM AND QUIET. SKIN: WASH AFFECTED AREA THOROUGHLY WITH SOAP
    AND WATER. REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE RE-USE.
    EYES:  FLUSH WITH LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES.
    GET MEDICAL ATTENTION. INGEST: SEEK MEDICAL ATTENTION.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:100F,38C
Lower Limits:1.0%
Upper Limits:6.0%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPRVD SCBA & FULL PROT EQUIP . IF
    H*2O IS USED, FOG NOZZLES ARE PREF. H*2O MAY BE USED TO COOL CLSD
    CNTNRS TO PVNT PRESSURE BUILD-UP & (SUPDAT)
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, ELEC EQUIP, SPARKS, &
    OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.
    APPLICATION TO HOT SURFACES REQS SPECIAL (SUPDAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE AND
    REMOVE WITH INERT ABSORBANT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE ONLY WITH ADEQUATE VENTILATION.
    AVOID BREATHING VAPOR AND SPRAY MIST. AVOID CONTACT WITH SKIN AND
    EYES.
Other Precautions:THESE COATINGS MAY CNTN MATLS CLASSIFIED AS NUISANCE
    PARTICULATES (LISTED 'AS DUST' IN SECTION II) WHICH MAY BE PRESENT
    AT HAZS LEVELS ONLY DURING SANDING/ABRADING OF THE DRIED FILM. IF
    NO SPECIFIC DU STS ARE LISTED IN ING SECTION, (ING 9)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF PERSONAL EXPOS CANNOT BE CONTROLLED BELOW
    APPLIC LIMS BY VENT, WEAR A PROPERLY FITTED ORG VAP/PARTICULATE
    RESPIRATOR APPRVD BY NIOSH FOR PROT AGAINST MATLS IN ING SECTION.
    WHEN SANDING/ABRADING THE  DRIED FILM, WEAR A DUST/MIST (ING 12)
Ventilation:LOCAL EXHAUST PREFERABLE. GENERAL EXHAUST ACCEPTABLE IF THE
    EXPOSURE TO MATERIALS IN ING SECTION IS MAINTAINED (ING 13)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
    ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH HANDS AFTER USING.
Supplemental Safety and Health
MFR'S TRADE NAME/PART #:TOUGH RUST PREVENTIVE ENAMEL BULKS -2. FIRE
    FIGHT PROC:POSS AUTOIGNITION/EXPLOSION WHEN EXPOSED TO EXTREME
    HEAT. EXPLO HAZ:PRECS. DURING EMER CNDTNS OVEREXP TO DECOMP PRODS
    MAY  CAUSE A HLTH HAZ. SYMPS MAY NOT BE IMMED APPARENT. OBTAIN MED
    ATTN. EFTS OF OVEREXP:NO OTHER INGREDIENT IN THESE(ING 4)

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>300F,>149C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:0.97 
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:BY FIRE: CARBON DIOXIDE, CARBON
    MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASTE FROM THESE PRODUCTS MAY BE HAZ AS DEFINED
    UNDER THE RCRA 40 CFR 261. WASTE MUST BE TESTED FOR IGNITABILITY TO
    DETERM THE APPLIC EPA HAZ WASTE NUMBERS. INCIN IN APPRVD FACILITY.
    DO NOT INCIN CLSD  CNTNR. DISPOSE OF I/A/W/FED, STATE (ING 8)

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.